Learn how to Replace Your Hydraulic Hose

The good thing about hydraulic hoses is that you can easily replace them, save the money you should use in hiring an expert to help you with replacing them. If you are going to replace hydraulic hose it is also important to replace it with a high-quality product.

There is a different type of product are available at a different cost. If are looking to buy Hydraulic part or other excavator parts then you can search online.  You can also buy genuine excavator parts online from Komatsu.

Here are some steps that can help you manage the replacement process easier.

Step 1 – Identify the problematic hose. This leak usually indicates an explosion considering the hose handles high pressure. A wet trail can take you directly to the source of your problem. 

Step 2 – Assess components to be deleted. To replace a damaged hose, you must remove some components and avoid confusion when reinstalling, you should label them when you remove them. 

Step 3 – Determine the load of the hydraulic component. Components served by the hose can explode if they are under pressure when releasing. Each attachment supported by a cylinder operated by a hose must also be chained or lowered to the ground so that it does not fall due to pressure.

Image result for hydraulic hose

Image Source: Google

Step 4 – Remove attachments and clamps. Apart from hydraulic cylinders, fittings that attach the hose to the system also need to be loosened and must be rotated on the threaded joint without turning other parts.

Step 5 – Pull the hose and clean it.  You can then remove excess oil from the hose before taking it to your supply store for new orders. You should also make sure you clean the equipment before replacing the new hose.

Step 6 – Install the end of the new hose. A special lid or clean cloth can be used to keep dirt and dirt from entering the hose when installing it again. Removable temporary plugs immediately fitting installed.

Step 7 – Reinstall fittings and replace other components. Torque can help connect fitting properly, but make sure you don't end stripping or damage the seal. 

Step 8 – Check engine and liquid levels. Bleeding may be needed for some hydraulic circuits before using the machine. Turn on the system and check for leaks. Clean previous leaks that contaminate the surface so you can easily see new leaks.